Comments

• Paul October 3, 2014 at 9:50am

  Hi all

  tks for joing me in this group
• 

  Ricard Pardell September 23, 2014 at 10:28am

  Hi all, I am starting a project where I want to add two pusher propellers to an X octocopter configuration.

  I wonder if anybody can give me his opinion on the feasibility of doing this on Arducopter.
• Chris Leech September 10, 2014 at 4:29pm

  Just throwing this into the mix here and I apologize if it is not the correct forum gents, but there is little time left to take advantage of this great offering. I thought it my duty to bring to your attention this invention from a German group of engineers that may very well put to rest much of FAA worries about LOS/ FPV and Drones falling out of the sky. Check this out. I signed up for an "Early Bird" of this device called the AP Manager (by Gizmotec) that combines two FC's of your choice (their test set up uses two Pixhawk, but it can be any combo, mix or match) and even if both fail it will still control a multirotor or fixed wing craft via the onboard Rx. Watch this http://igg.me/at/AP-Manager/x
• Developer

  Randy September 2, 2014 at 5:29am

  @Austin,

  Make sure that on the MP's radio calibration screen, the green bar for the pitch moves in the opposite direction to the physical stick on your transmitter.  If it moves the wrong way, fix it in the transmitter not by adjusting any arducopter parameters.
• 

  Johann van de Venter September 1, 2014 at 3:28pm

  Austin

  Is simple or super simple mode active?
• 

  Austin Laws September 1, 2014 at 2:28pm

  Pixhawk elevator/pitch reverse issue. I just can not get the pixhawk to reverse at all. reverse on my aurora 9 but makes no odds. pick up quad and aileron is fine when I lean it to the right the right motors spin up to relevel it same as when I do it on the left side. but when it comes to the elevator I lean it backwards and the back motors slow down. totally fed up and utterly confused. Can someone else?
• Spencer Willis July 25, 2014 at 2:22am

  Thanks mP1. Unfortunately we are leaving early Monday morning so I can't really get it quickly enough from Sydney.

  @David - do you have a web portal? I will order from you in the future.
• Moderator

  David Anders July 25, 2014 at 2:09am

  Hi Spencer,

  I have a heaps of black motor related stuff (i'm a 3DR distro).  Let me know if you don't have any luck elsewhere.
• mP1 July 25, 2014 at 1:37am

  Ive got a spare entire black motor if you want it, in mybox of kool stuff(tm). Pretty sure it works.
• mP1 July 25, 2014 at 1:34am

  Oh ouch i thought you meant the bolt to keep the prop from flying off :) not the shaft thingo.