Discussions

APM Planner is stalling at "radio setup"

Posted by francisa. on July 7, 2011 at 9:45pm

hi everyone, just got a setup, trying to perform initial conf. but APM planner just stalls at "radio setup", CLI is the same.

anyone? Tried two receivers, different brands.

 

I haven't got a power distribution board, but that should be alright, I have the APM powered from an ESC, batt. ground and ESC ground are joined.

 

What am i doing wrong? Sorry if this is a noob question

 

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • francisa. July 11, 2011 at 5:50pm
    Only power, A and C LED light up, B and PPM LEDs remain off (mux is also off)
  • francisa. July 10, 2011 at 9:30am

    still stuck.. anyone?

    can't get new board to read inputs

  • francisa. July 8, 2011 at 1:29am
    - mux led is off
  • Developer
    Michael Oborne July 7, 2011 at 10:01pm
    are you powering the receiver?
This reply was deleted.

Activity