apm1 3 of them just stop working!!!
Ok, I almost done with this, after 10 great flies with my skyfun jet, I just try to install my apm 1 with IMU board on one of my Quad and it did it again this is the no.3 apm board that suddenly stop working, the firts one stop to have signal input from the receiver , I replaced it, after many flies the second one just stop
conecting via usb no been able to load codes again the ATMEGA2560 stop working, now no3 just stop woking too all sensor are dead, all wired acoording to the manual, what is hapenning I doble everything help!!!!
Replies to This Discussion
-
ModeratorPermalink Reply by John Church on -
Not good, Valentin! Got any pictures of your wiring? Maybe we can spot something that you missed.
-
Permalink Reply by valentin colon on -
jhon I did recheck my wiring, any ways I will send you picture...thanks
Social Networking
Top Content
Contests
Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.A list of all T3 contests is here.
Groups
-
German Ardu-Group
106 members
-
ArduCopter User Group
1279 members
-
ArduPlane User Group
671 members
-
ArduRover User Group
183 members
-
Andropilot Users Group
182 members
Advertisement
© 2013 Created by Chris Anderson.
Powered by
