Configuration problem with RC Graupner MX-20

Configuration problem with RC Graupner MX-20
The RC is not recognized in the program, the movement of the stick is not displayed.
I did the manual calibration of the ESC and it is ok, so the receiver and transmitter are connected
The difference compared to the wiki is that I had to connect the ESC to channel 1 instead of 3
Any advice?
thanks

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • news
    I managed to configure the RC in a CLI
    tests are ok
    in graphics mode, but the bars do not move
    Is this normal?

This reply was deleted.

Activity