Hello,

I switch my battery today from 4S 3700 mAh to 3S 5000 mAh and my Hex flies poorly.  I was hoping the new battery would work better.  I thought my configuration file was the default with a little tuning.  I had lowered the Stabilize roll and pitch from 4.5 to 4.  I reset these values back to 4.5 after installing the new battery.  When I flew the flight was wobbly and just poor.  I kept the Hex close and low for fear of a crash.

My question is where can I find the default configure files for both for Hex and Quad?  I went through the wiki manuals and didn't find them, nor did I find them in the download area.  I also recent upgraded to 2.8.1.  Both my Quad and Hex are 3DR kits.

Thanks
Richard

Views: 672

Reply to This

Replies to This Discussion

Gee, I get to answer another of my own posts.  LOL.  But not really...

I found when looking more closing at my parameters that I had set the Throttle Rate P at 30.3.  Ouch, no wonder it flew so poorly.  That's what happens when you rush things, I so wanted to see how my new battery would work, I flew on my lunch hour today. 

Rush, rush, crash, crash.

But, my original question still stands, where can I find the default parameter files for both the Hex and Quads sold by 3DR?

Thanks,
Richard

Don't know if this is of any help to you Richard, but I always take a screen shot of the default values for a new APM.

 

This is what I have for 2.8.1.

 

Hope this is what you are after.

Thank you. Is this for Hex or Quad?

RSS

DIY Drones Monthly
Newsletter

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Pylon Race, is here

© 2015   Created by Chris Anderson.

Badges  |  Report an Issue  |  Terms of Service