How do I reset PIDs to default?

Can anyone give me the default PIDs for 2.8.1?

Thanks

Replies to This Discussion

Permalink Reply by Richard Boyhan on January 10, 2013 at 8:12pm

Log into terminal mode and I believe you go to setup and either erase or reset or both, then just reload the firmware for 2.8.1. Sorry I don't have access to my mission planner or I'd give a more exact steps.

▶ Reply

Permalink Reply by Elvis on January 10, 2013 at 9:09pm

Thank you RB, I'll give that a try.

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM Project vs DJI NAZA and WOOKONG
2	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
3	APM Copter 2.9.1.b has been released
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	ArduCopter-3.0 ready for wider use
6	10k autonomous flight - telemetry guided flight, and other APM tests!
7	Drone shot down by police
8	MAAT final version is being tested
9	Getting ready for Arducopter 3.0
10	Help Tuning Arduplane 2.73 With A Large Slow Airframe

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.