Comment by Rolf M. on June 26, 2012 at 11:46am

This is a rearly good idea

Rolf

Comment by Dan "HotSeat" Neault on June 26, 2012 at 12:03pm

Tried this on a spectrum DX6i, some time ago, no luck, software on the transmitter needs to be changed :(

I just changed the ardu code to different combination of binary switches

Comment by ARHEXA on June 26, 2012 at 12:07pm

Of course, the switch must replace an existing continuous potentiometer on your TX.

you can't replace a 2 or 3 position switch with this one and expect it to work, though it might, depends on the TX.

Comment by Simone Chiaretta on June 26, 2012 at 1:23pm

If I buy the DIY one, will it come with a wiring diagram?

Comment by Taylor Davis on June 26, 2012 at 1:46pm

Just bought one. Thanks and I'll let everyone know how it goes.

Comment by ARHEXA on June 26, 2012 at 1:51pm

Simone, The schematic is even shown above in this post ! you will get a printed version of it and the components needed.

Taylor, Congrats ! please come back and tell us how it works for you

Comment by arashi on June 26, 2012 at 2:06pm

Ordered, Thanks!

I have one of your switches already and it works great.

Comment by Paul Mather on June 26, 2012 at 2:47pm

And by ANY you mean SOME! lol, j/k. This is a great idea. You probably should revise the title and content to indicate it only works on radios with a pot knob or 3 position switch. If you only have 2 position switches, there's a very slim chance it will work for you.

Comment by Scott James on June 26, 2012 at 6:31pm

Had it been tried on a Futaba 9C?

Comment by Nick Squillace on June 26, 2012 at 7:46pm

Will be ordering one soon, looks great!

Comment

• ‹ Previous
• 1
• 2
• Next ›
• Page