3DR Iris Quadcopter Extended Legs - Set of 4 - 5 1/4 Inch Rise (133mm)

These are some 3D Printed legs I made for some friends I made one extra set. They are a direct replacement for the stock legs that slide into the end of the arm. Not the ones that need screws to hold them to the rail and are as outboard as you can get to eliminate those "leg in shot pics". These can utilize the stock grub screws but do not need them as they are an "Interference" tight Fit. Just slide them in. they can be mounted "Toe In" or Toe Out" as desired.

I have moved exclusively to using my custom 3DR Iris Stealth Retractable Leg System,  so I do not need them.

The Photo is of the actual 4 Legs. The Mounted/Installed photo is an ACTUAL Leg in a "Toe In" Installation.

3DR Iris Quadcopter Extended Legs - Set of 4 - 5 1/4 Inch Rise (133mm)

Views: 348


Reply to This

Replies to This Discussion

Ian did you sell these extra legs for the iris yet? I want a set as my gimbal is coming this week. the 3DR ones i have are too heavy. thx, jay. jay@trebfl.com.

Reply to Discussion



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service