Discussions

This rig is setup for shooting video and has proven to be rock solid. The Y frame means you'll never worry about props getting in the frame and the redundant motors help safeguard against possible motor/ESC/prop failures as well as provide a very stable platform even in high winds. The Alt Hold mode the Pixhawk offers along w/the gimbal make long breathtaking shots near effortless. 

This craft is in great condition. It was factory assembled by 3D Robotics. I've been holding off for awhile but it's time to sell this Y6. I started a new job back in January and I just dont have time for the side gigs anymore. I'm in Austin and local pickup is preferred but I am willing to ship. 


1 x 3DR RTF Y6:
1 x Pixhawk
1 x 3DR Power Module with XT60 connector
1 x 3DR u-blox GPS with magnetometer
6 x 850 Kv brushless motors
6 x 20 Amp ESCs with SimonK firmware
1 x 3DR Radio 915 MHz
1 x FrSKY X8R
4 x 4S 6000 mAh LiPo Power Pack
6 x APC Propellers 10X47 Push-Pull Set 
1 x 3DR Video/OSD System Kit:
1 x Camera with 1/3" Sony Super HAD CCD 520 TVL Camera Resolution
1 x 5.8 GHz Video Transmitter and Receiver
1 x MinimOSD Kit - Overlays Telemetry Data
1 x Pelican 1610 case
1 x Tarot T-2D V2 Gimbal
1 x SmartFPV 3ch Video Switcher (switch between nose camera and GoPro)
1 x RTF Y6 Replacement Kit:
2 x 850 Kv brushless motors (including mounts)
2 x 20 Amp ESCs with SimonK firmware
1 x replacement leg (carbon fiber, screws, and spacers)
2 x square tube replacements (one black, one blue)

**GoPro NOT INCLUDED**