Discussions

Posted by James Hall on January 15, 2008 at 3:24am

Which is better, a conical tip or chisel tip when soldering components, pins and wires to a prototype board?

You need to be a member of diydrones to add comments!

Email me when people reply –

James Hall January 16, 2008 at 6:51am

I was successful in solder my first header pin to the board. Question, is 4.7K resistor always required on the signal line to each servo for the propeller proto board?
3D Robotics

Chris Anderson January 15, 2008 at 1:16pm

SparkFun just started a series of great soldering tutorials. Start here.
James Hall January 15, 2008 at 8:16am

Does anyone have any helpful advice for me on soldering circuit boards?

This reply was deleted.

Jose Araujo liked Jose Araujo's profile

spencer harvey liked spencer harvey's profile

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.