Discussions

Posted by Julie Macfarlane on January 16, 2011 at 6:01am

Not sure how to do this. Another noob question for you.

I can upload the code to the unit with no problems, but I cannot get the CLI to run it seems.

I plug in the unit to USB

I start Ardudino (0021) and set the com port and speed

Set the CLI switch towards the rear (pins), click the reset button and the ABC leds walk.

Click on Serial Monitor and. Nothing. I am not getting the menu as described.

You need to be a member of diydrones to add comments!

Email me when people reply –

Julie Macfarlane January 16, 2011 at 6:51am

Ok. I had the SerXbee open. Now when it connects I get this:

<text>

~ÿüààü

</text>
Distributor

Martint BuildYourOwnDrone.co.uk January 16, 2011 at 6:19am

What speed have you set the baud rate to?
Sebastian Gralla January 16, 2011 at 6:07am

did you comment/uncomment anything in the code? -> pls post it ;-)

This reply was deleted.

Neville Rodrigues liked Neville Rodrigues's profile

Santiago Perez liked Santiago Perez's profile

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.