Discussions

Thermopile sensors in England

Posted by Giles Barton-Owen on August 21, 2008 at 9:10am

Is there a way to get the thermopile sensors in England. Farnell sells a ZTP-135S — GE SENSING / THERMOMETRICS, but this a different sensor, I could by a board fine but the sensors are the problem. any clues, could I use a different gain in the amp?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

Giles Barton-Owen September 4, 2008 at 9:27am

I think I will work out the gain needed for the farnell one
Michael Molloy September 3, 2008 at 9:05pm

http://shop.halfbase.com/product_info.php/cPath/37/products_id/45

Try half base only $8 each or a built board for complete $55 (USD)

I assume it is for Paparazzi???
Giles Barton-Owen August 23, 2008 at 3:20am

Why can't you just adapt the amp circuit to use the Farnell ones? It shouldn't be too hard, I would do it if I knew the equations!
Giles Barton-Owen August 21, 2008 at 10:40am

There's one Farnell sells the data sheet is at http://www.gesensing.com/downloads/datasheets/920_159a.pdf
Giles Barton-Owen August 21, 2008 at 10:23am

Does digkey deliver to the uk? and if so how much? It looks expensive like $70 to deliver, that is too much
3D Robotics

Chris Anderson August 21, 2008 at 10:20am

Is the problem with going the DigKey route the cost of shipping from the US?

This reply was deleted.

Activity

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.