Discussions

AC2.9.1b: Gimbal servo going crazy when RC INput is selected

Posted by Stefan Gofferje on April 23, 2013 at 6:42am

Hi,

I'm trying to get manual overideable gimbal servos configured on an APM2.5. I got 2 Corona Digital Metal Gear servos. When I set them to stabilize only, everything works just fine, on RC7/8 or RC10/11.

As soon as I add an RC channel as input, the servos go totally crazy. When I turn the pot on the TX, the servo jumps between min and max back and forth. This happens on RC7/8 as well as on RC10/11.

Is there any solution to this?

-S

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

Jean-Jacques April 29, 2013 at 10:06pm

Hi, Maybe because of the radio calibration of the channel output from your tx. I have thé same issue but I'm not at home to try this solution: calibrating all the 8 channels, including moving pots, not only sticks.

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile

Santiago Perez liked Santiago Perez's profile

More…

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.