Alexmos 3 axis setup

This may have been posted already so I apologize if it has.

I have a brushless gimbal with the new Alexmos 3 axis controller on it.  I am a bit frustrated.  I can't seem to get it to work properly..  After a lot of PID setting and slight tweaks I have it pretty smooth, but any rotation it does, the camera always rolls and stays ducted.  I have done the 6 axis calibration, gyro calibration and all the parts of the gimbal and IMU are straight and square...

Has anyone else encountered the unwanted "roll"? and is there a fix for it...

Thanks

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Hi Shawn,

    I hanged up an 3axis alexmos brand new rctimer gimball yesterday and I did some basic setting. All seems to be ok. Now I start an invastigation how to control yaw axis using an onboard compass of APM. Have you already solve the problem you described above?

    Regards Bert

    • Hello.  I have it close, but it still drifts (rolls) if I rotate it much.  If I go straight forward it's pretty spot on, but as soon as I pan a little it starts to go dutch on me.

This reply was deleted.

Activity