Guys i need help because of my apm 1.0 when i connect the apm to may computer it successfully connect but the flight data displayed disarmed and when i tilt the apm the screen did not respond anymore.. please someone tell me whats going on in my apm? is my apm already destroyed? thanks------------
You need to be a member of diydrones to add comments!
There might be a connection issue between the APM and the IMU shield. Check the pins with a meter to make sure they all have a good connection. Also try flashing the firmware and erasing the flash (see the wiki). If those don't get you anywhere the board might be toast. Did anything happen to it, too high of input voltage, dropped, get wet?
Replies
There might be a connection issue between the APM and the IMU shield. Check the pins with a meter to make sure they all have a good connection. Also try flashing the firmware and erasing the flash (see the wiki). If those don't get you anywhere the board might be toast. Did anything happen to it, too high of input voltage, dropped, get wet?