Hi.
My name is Patrik from Sweden. I have a problem :)
All the troubles i have had with the Apm 2.6 have i solved by Reading here, on internet or youtube.
But this i dont understand.
I have made a 2 axis gimbel prototype but i cant get the servos to work. The servo just travell at one direction then bind?
I have connected the RC 10 an 11 channel. Powered + and - with a 5v Bec. Load the latest firmware.
I have tried all in missionplanner, i Think?
The servo its just stuck in one postition?
Any ideas?
Replies