Discussions

APM and radio setup

Posted by palo sestak on March 12, 2011 at 4:20pm

Hi folks,

i often upload modified APM software via Arduino. The question is: is it alwasy need to do radio setup (calibrating, modes setup) after the APM software is uploaded?

I'm going to be tired still to do the same action... Isn't  that so that the calibrated values, mode setup and everything what can be setup through CLI is stored in dedicated EPROM part?

 

Palo

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • 3D Robotics
    Chris Anderson March 12, 2011 at 5:54pm
    Sometimes major new versions of the code reconfigure EEPROM and it's a good idea to reset and redo the radio config. But normally that's not necessary.
This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…