Hello,

I am trying to configure Battery failsafe on my Quad.

using mission planner software I have calibrated my battery monitor, and selected a voltage for battery failsafe, and using the reset switch given on the apm i had rebooted it, now i can verify FS_BATTERY_VOLTAGE in full parameter list but when i am arming my copter it is not triggering the battery failsafe even after the voltage drops lower than 1V i have selected for battery failsafe.

Views: 27

Reply to This

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service