Just recieved my APM2.0 board. Very pleased I might add !! ... delivered to France in under 48 hours !
I have the Turnigy 9x radio with latest ER9X firmware. I have been setting up the APM today, nice and simple, no problems.....Until...I wanted to set up the 3 pos toggle switch for loiter ect.... I have fallen into a heap of info for changing settings on the 9x radio, that for many might be simple to understand. For me it might aswell be in hebrew. I don't understand ANY of it. Is there not a up-loadable firmware that is just plug'n'play ? I have the pdf manual for the er9x, but it sheds no light for me. I have looked through some of the related "walk throughs" on diydones forum, but I still cannot grasp what they are doing or how in relation to mode switch values. Please help !
Replies
Ok, I think I have got a "little" further. I found I had to use eepe to change some settings. I found this post by davidbuzz :
.................................................................
Reply by davidbuzz on May 19, 2011 at 6:19pm
Using the er9x firmware, and eepe software to setup the channels, I set my channel 5 ( the 3 position switch) up like this:
( note that the three position switch is seen in software as three toggle switches called ID0,ID2,ID2, and only one of these is on at any time )
CH05 R -100%MAX Switch(ID0)
R 0%MAX Switch(ID1)
R +100%MAX Switch(ID2)
........................................................
I could not find a setting that was called "max" but I found one called "full". I don't know if this is the same ?
I have copied what I can see on my screen. Please can someone verify that this is the same as the setup above ?