Hello all,
My APM2 arrived today and is now soldered together. I had just one question though.
There are 6 single pins that seem to come from the main board to the daughter board. Am i to solder the daughter board to the main board with these 6 single pins?
I found this picture which leads me to believe that I am supposed to solder these to the daughter board, I just don't want to make an extremely difficult to undo mistake.
Circled in red here:
Thanks for your time,
-Rob
Replies
I just bend them all outward so that I could remove it easily.
Rob, On my (factory soldered board) they have a small blob of solder on them holding the daughterboard permanently in place. I think they are there as locating pins and but also seem to be GND and V+ so I would solder them in.
Paul