Discussions

Ardu imu code

Posted by honish wase on June 16, 2011 at 2:14am
i m makin ma own quad and i hav oredrd for ardu imu board...i hav two source codes wth me..1.ArduIMU and 2. Quad1_mini...so out of these whch code shld i use??anthr doubt is while dumping the code do i need to power the arduimu board?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • honish wase June 16, 2011 at 4:14am
    ya got hte connections but i tried programmimng the board it gave no errors while compiling but while loading it cudnt load the program...
  • honish wase June 16, 2011 at 3:09am
    also suggest me the connections of escs to the li po battery
  • honish wase June 16, 2011 at 3:06am
    so i dont need to power supply it from external power supply of 5v
  • Lenz Grimmer June 16, 2011 at 2:37am

    If you want to use the ArduIMU+ (v2 flat, I hope) to control a Quadrocopter, you would have to go with Jose Julio's ArduIMU quadcopter software. The original ArduIMU code is just that - an IMU. I've documented the building of my ArduIMU+ - based Quadrocopter here. I started with Jose's software, but modified it somewhat.

    And yes, in order to upload the firmware to the ArduIMU, it needs to be powered on. The FTDI programming cable should take care of that.

This reply was deleted.

Activity