Arducopter 2.8 problems


Hope someone can help

I have a f450 frame with an arducopter 2.8 FC. I have set everything up (correctly, I think) and after going through the setup wizard, everything seems to be ok. I can get as far as arming but I cannot get the motors to move.

Googling leads me to believe it could be an ESC problem I tried to calibrate the escs using the throttle to the top method. The only problem is, I don't get the beeps when I lower the throttle back down.

I've tried everything I can think of

Any help?


You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –


  • Try looking at instructions on how to update the encoder firmware or how to enable Failsafe.
This reply was deleted.


David Hori liked Isabella Domi's profile
gotham liked gotham's profile
Dec 3, 2020