I am looking for specific instructions on how to connect four of these GP2D12 to my Arducopter. They advertised the units as Arduino compatible, but I see no leads on how to install them. All I have is a program which I need to input to the firmware.
DO I use the four vacant inputs to connect the four sensors? I hope somebody who had successfully installed these sensors will share the detailed steps. Thanks
They use JST leads which have 3 lines. Vcc, Gnd and Analogue.
Obviously the Vcc goes to your 5V rail, Gnd goes to the ground rail and the Analogue goes to analogue points on the APM/IMU. If you look at the APM/IMU board two analogue point have all three connections next to one another.
Replies
They use JST leads which have 3 lines. Vcc, Gnd and Analogue.
Obviously the Vcc goes to your 5V rail, Gnd goes to the ground rail and the Analogue goes to analogue points on the APM/IMU. If you look at the APM/IMU board two analogue point have all three connections next to one another.