Discussions

Ardupilot mega no servo movement in stabilize mode

Posted by tim on September 20, 2011 at 11:23am

I have run in to the following problem with ardupilot mega :

I have installed ArduPilotMega1.02 and 2.1 and got the same problem.

Setup the radio and configured the first 4 channels.

Setup the modes and configures channel 5 to be my mode switcher (Manual and Stabilize)

The switch is moved to be closer to the servos as mentioned in the manual.

When I switch ch-5 to manual, using my futaba transmitter I can see the servos are moving.

Problem : When I switch ch-5 to stabilize mode and move the airplane, I got no movement on the servos.

 

Xbee Problem, I do not receive and data from the xbe trans-receiver. But when I run the xbee test I receive data”@ABCDEFG…”

 

 

 

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Wiki Ninja
    Gent Armedo September 20, 2011 at 11:32am

    Hi Tim,

    I got the same problem before but I upgraded to 2.24 and it all went away. see this thread: here

    and this: also here

     

    Download the newest Mission Planner (Google Arduplane Repository), upload the newest code to your Arduplane then go undergo the setup.

     

    Hope these help.

     

    Best Regards,

     

    Gent

This reply was deleted.

Activity