Discussions

Posted by Paul Glarison on September 11, 2014 at 2:08am

I want to connect my landing gear servos to apm.please inform me how to pin my wires to apm.

You need to be a member of diydrones to add comments!

Replies are closed for this discussion.

Michael Visser November 27, 2014 at 12:09pm

Reviving this, if A10 and A11 are in use for a camera gimbal then what A# is available for controlling a switch servo/servo trigger via receiver CH7 or CH8 within APM 2.6?

This reply was deleted.

Jose Araujo liked Jose Araujo's profile

spencer harvey liked spencer harvey's profile

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.