Hi all, I see this issue and variations of it have been around for a while. This is my first build so it has been very frustrating to say the least.
After passing all the basic setup's in MP I tried to run up the motors but they only get to about 15%.
I had a look at the pwm signal out of the PX4 with an oscilloscope and can see the motors start at about 50% duty cycle then as I increase the throttle the motor speed increases slightly and they stay at that speed even though the throttle is at max and the duty cycle is at about 90%.
So I have throttle range but the esc's don't respond. I have flashed esc's to the latest firmware.
Also I can't get passthrough to work as well, maybe related to the esc's?
Has anyone had this type of problem.
DYS Blheli 30A V2
PX4.2.8
Replies
Solved setting the “Low RPM Power Protect” to “Off” in esc setup.