Discussions

BlimpDuino old Hat?

Posted by ken wood on August 1, 2010 at 3:46pm
I look through this forum and I think all posts are from 2009 so i hope BlimpDuino is not old hat.  As I am new to all things 'Duino" and all of RC I have a couple of questions: How can one test a servo without hooking up to the board?

I'm pretty sure I toasted the one that came in the kit. As hard as I tried to NOT get a drop of glue on the shaft I think I did. 

Also, when I looked at the sketch files after I unpacked the .ZIP I see there are pde's for all of the electronic parts.  Is there any documentation on use of these codes to test individual parts.

All in all this has been a very enjoyable project.

ken wood

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Terry King December 8, 2012 at 7:48am

    What's the status of BlimpDuino? Where can I buy one??

    Thanks!

    Regards, Terry King

    ...In The Woods in Vermont, USA

    terry@yourduino.com

  • Simon November 4, 2010 at 6:18am
    Maybe we could have something like this :


    See this web-site.
  • Hans Gerwitz November 3, 2010 at 4:37pm
    Any ideas when kits will become available again, either here or through MakerShed?
  • 3D Robotics
    Chris Anderson August 1, 2010 at 5:58pm
    Blimpduino is still very much supported. It's a finished product and out of beta, so that's why you're not seeing active development posts.

    If you need another servo, just PM me your address and I'll send you one.

    Those individual .pde files are not for the individual components (although it may look that way). It's best to just load the code, and keep the FTDI cable plugged in and watch the Arduino IDE serial monitor to see the output from the various sensors.
This reply was deleted.

Activity