Hi,
I just have another problem with my Hexacopter and APM 2.5.
When I connect the two servo cables of my camera mount to pin 11/10 and set it up in the mission planner the servos are moving like they should. But only for just 1 or 2 seconds. Thereafter my APM reboots and nothing is working any longer till I disconnect the servo cables. Is there any knack for it?
Cheers,
Markus
Replies
Your servos are too power hungry and dragging down the +5V on the APM low enough to reboot.
If you have a scope you can verify this by watching the +5V line.