I have the latest software Mission Planner and ArduPlane but I can not find Ch6 Ch7 Ch8 options there. There is no Extended Tuning tab in Config/Tuning and no such options in Full parameters list. What I'm doing wrong?
But I was able to configure the servo on one of the channels of camera gimbal.
Replies
I just set RC##_Function = 1 to enable channels mapping from transmitter
http://diydrones.com/forum/topics/how-to-assign-a-receiver-channel-...
Which Mission Planner software are you trying to use? If you are on APM Planner 2.0 you need to enable the advance mode from the "File" menu.
MP 1.3.19 and APM Planner 2.0 (advanced mode enabled) I guess there is no such options in ArduPlane though it's in wiki but with reference to ArduCopter