Hello,
I have a Flysky I6 radio controller and the receiver of this radio has got damaged. Can i connect my controller with Xbees to transmit the data to my copter. i have seen somewhere that port at the backside of radio controller has PPM,TX,RX and GND pins. I connected oscilloscope to get the data but i could only see the PPM signal. some strange, very low voltage pulses were coming from Tx pin.
Please help me with this.
that how can i transmit the radio control data to the copter
(i was able receive the PPM pulse in arduino and send it to copter but i dont want to put a arduino at the radio control. i want to transmit the data directly )
Replies