Shouldn't APM Planner Gui give direct interface to control these channels actions because setting these channels everytime we need either CLI or Arduino IDE
You need to be a member of diydrones to add comments!
This reply was deleted.
Shouldn't APM Planner Gui give direct interface to control these channels actions because setting these channels everytime we need either CLI or Arduino IDE
You need to be a member of diydrones to add comments!
Replies
channel 6 is already done.
using the TUNE param
I am using APM Planner 1.0.85 with 2.0.49 AC2. Using Channel 7 we can set Simple mode, Auto Trim and other options. and with Ch 6 we can set it as Gain/parameter adjustment
what firmware are you talking about, and what options?