I am using the latest greatest version of the MIssion planner and AC3.3.1 for the pixhawk. I am using a Drotek M8N XL GPS & MAG.

I am facing a strange problem when I perform a compass calibration over the wireless. All the points get collected at the edge of RED axis instead of centring at the intersection of all the axis. As a result of this none of the white dots get matched and I cannot complete a compass calibration.

If I use the USB wire to connect to the pixhawk and perform the compass calibration, when it starts for a few seconds the points again get accumulated towards the edge of the RED axis however immediately get reset to the centre allowing me to complete a successful calibration.

Effectively what this means is that I cannot perform a compass calibration when the pixhawk is connected over wireless. Any thoughts on why this could be happening?


Views: 235

Reply to This

Replies to This Discussion

Any Suggestions?

Did you ever find an answer to your problem?

Reply to Discussion



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service