Followed the wiki on the first setup using the configurator. After doing the tranceiver configuration turning all the sticks and finding all the buttons I try to click the "Save" button on the little dialog that stayed up but after a couple of seconds a message comes up saying it was unsuccessful and if i would like to cancel or try again. If canceling everything continues except a message that the aux channels didnt seem to be configured. Anyone know what could be the cause?
Also wondering about the accel values, its a bit unclear in the wiki but are you supposed to change the values in the textbox until the accel graph gets close to 0? Mine seemed to be at almost 0 +-5 and the textboxes had the values 2048.
Replies
just to say my oppinion about TX calibration: I never did that and won't do it, my quad is flying very well without any problems
the accel graphs should read 0 (except the z-axis) don't care what the textboxes say (just modify it)