Discussions

dont see any hardware tabs in my mission planner

Posted by dincer hepguler on May 26, 2013 at 3:34am

i had MP 1.2.33 installed on my pc and yesterday i run it first time to test my APM2.5 for my rover project. it told me that there were an update awailable when i run MP. i did the update and it updated to version 1.2.51.. but now i cannot see any hardware options on my config tab. there is only 3dr radio, antenna tracker, planner tabs there... i was planning to add a Maxbotics ez1 sonar... i uninstalled andf reverted to previous 1.2.33 version but the result is the same. any ideas?.. i am a newbie... bought my APM2,5 lately and beginning my project... pls help...

dincer hepguler

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Admin
    Thomas J Coyle III May 26, 2013 at 4:55am

    @dincer,

    Did you establish a Mavlink connection with your APM2.5 and download it with Ardupilot code prior to trying to use the configuration tab to set up your hardware?

    Regards,

    TCIII

This reply was deleted.

Activity