Hi Everyone
I am stuck at the esc calibration stage.
My esc's seem to behave erratically.
I am following this manual--
http://code.google.com/p/arducopter/wiki/AC2_ESC
The motors seem to power on and off on their own. I seem to have no control. Sometimes i am able to start the motors using the throttle control in the radio, but then i can't kill them even by cutting the throttle.
Sometimes they refuse to start up altogether.
I am using the airtronics RDS800 radio
Any help will be most appreciated.
Replies
So what values should these be
1)brake---on/off?
2)Battery--Lipo-->noBrainer
3)cutoff mode- Soft-cut/Cut-off
4)cutoff threshold-Low/Medium/High
5)Start mode--Normal/Soft/Super soft
6)Timing--Low/Medium/High
7)Default??