Discussions

ESC constant beeping with pixhawk 2.4.8

Posted by Priyansh Raj Purohit on October 28, 2018 at 9:15pm

Hello everyone!

It's my first discussion on DIY DRONES. I had to do this because of a very annoying ESC beeping problem. I have 30amp ESC connected to Pixhawk 2.4.8. There is no beeping when I directly connect the  ESC into X8R receiver's ch3. Motor responds to Taranis X9D very well. But as I connect it to Pixhawk, it starts beeping rapidly. Though it was working well with Pixhawk few days ago and suddenly faced this problem.

I've tried the following:

1) Center trim throttle, put throttle stick to min, reverse thr etc.

2) Increase down the value of ch3_min from 982 to 1000.

3) Check the connection of battery>power module>esc>motor.

Since this issue is not new, I've followed many suggestions from different forums but were all waste for me.

Please anyone help me solving the issue.

Thanks!

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Priyansh Raj Purohit October 29, 2018 at 9:13am

    Thanks for reply.

    I had tried this before two times.

    But good news is I uploaded ArduRover and then ArduPlane back.

    Issue is resolved!

  • 3D Robotics
    Chris Anderson October 28, 2018 at 9:54pm

    You might want to re-calibrate your ESC. Follow instructions by the ESC manufacturer

This reply was deleted.

Activity