Discussions

Hello everyone!

It's my first discussion on DIY DRONES. I had to do this because of a very annoying ESC beeping problem. I have 30amp ESC connected to Pixhawk 2.4.8. There is no beeping when I directly connect the  ESC into X8R receiver's ch3. Motor responds to Taranis X9D very well. But as I connect it to Pixhawk, it starts beeping rapidly. Though it was working well with Pixhawk few days ago and suddenly faced this problem.

I've tried the following:

1) Center trim throttle, put throttle stick to min, reverse thr etc.

2) Increase down the value of ch3_min from 982 to 1000.

3) Check the connection of battery>power module>esc>motor.

Since this issue is not new, I've followed many suggestions from different forums but were all waste for me.

Please anyone help me solving the issue.

Thanks!