I am using a BeagleBoneBlack to generate PWM signals for an ESC. I am using an Afro multirotor ESC 20A. I am confused with the PWM frequency.
The link below is the manual for this model.
In default setting, it is mentioned "for PWM motor stop/arm below 1060us and full power at 1860us." Further more in the hobbyking website,
it mentions input 1kHz. Now I am confused because 1kHz is 1000us. This would not even start the motor.
Also in the manual->general operations section it is mentioned default PWM frequeyncy is 18kHz with 800 steps. Again 18kHz is 55us.
What am i doing wrong here?