Hey! I just finished building my first quad! Custom made aluminim frame, led lighting and custom coded controller on an arduino nano, everything weighted 310g, including battery :D Specs:
-Turnigy 1811/2900kv
-Turnigy Plush 6a flashed with BLHeli
-Turnigy Nano-tech 2000 mah 20-40C
-Turnigy 9x TX and 8ch RX
-6030 Gemfan propellers
-Arduino Nano and MPU6050
But then something terrible happened. I was just setting up the PIDs and everything was going fine, it was almost ready to fly untied. But after turning it on and off again a motor wouldn't spin. It didn´t even beep, the other three are fine. Nothing happened, no crashes, smoke nor anyhing. I just disconnected the lipo and connected it again and it was like that! Its a Plush 6a flashed with BLHeli.
Any idea what could have gone wrong?
Thank you!
Replies
Solved it. I don´t know why it stopped working, but started working again after I reflashed BLHeli. Bug perhaps?