Posted by Ross Elton on December 9, 2012 at 5:32am
Hi. My build is really frustrating me. I've gone through and calibrated my turnigy 9x to my APM 2.5 board. I've successfully calibrated my TBS Discovery ESCs. However once I have calibrated the ESCs, I cannot arm them. I am running the latest code on the APM board.Help please!!
You need to be a member of diydrones to add comments!
Ok. A bit of an update. When I switch my quad on. And wait a few seconds I get a solid blue LED and a flashing red LED.
When I go through the arming process (no throttle, yaw full right), the blue and red LEDs begin to flash and then after a few more seconds, the blue LED goes solid again and red flashes.
the orange RX/TX LEDs are flashing.
I re calibrated my ESCs successfully with the auto mode. I can confirm I an in stabilization mode and have a GPS lock.
Replies
When I go through the arming process (no throttle, yaw full right), the blue and red LEDs begin to flash and then after a few more seconds, the blue LED goes solid again and red flashes.
the orange RX/TX LEDs are flashing.
I re calibrated my ESCs successfully with the auto mode. I can confirm I an in stabilization mode and have a GPS lock.
Appreciate any help.
Are they the standard ESC's that come with the Discovery kit? Or did you get different ones?