Discussions

Posted by shawn vatcher on September 3, 2009 at 3:20pm

Just wondering if anyone knows where to get a XY and Z sensor that is compaitble to ardupilot. they are illusive apparently.thanks

You need to be a member of diydrones to add comments!

Email me when people reply –

shawn vatcher September 3, 2009 at 4:36pm

Sorry didn't see your post there. Thanks for the promt supply save a set for me
shawn vatcher September 3, 2009 at 4:34pm

They are out of stock. Isent them a email asking when they might be in and had no reply yet. Only been a couple days tho I'm sure they are just busy
3D Robotics

Chris Anderson September 3, 2009 at 4:16pm

We're out of stock at the moment. Should have them back in a week or so.
Admin

Thomas J Coyle III September 3, 2009 at 4:14pm

Shawn,

The DIY Drones Store has them for sale: http://store.diydrones.com/ProductDetails.asp?ProductCode=SE%2D0002...

You cannot mix and match the FMA XY and Z sensors with the DIY Drones Store sensors.

Regards,
TCIII

This reply was deleted.

Neville Rodrigues liked Neville Rodrigues's profile

Santiago Perez liked Santiago Perez's profile

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.