Discussions

I can not calibrate throttle channel

Posted by Tomas kasanicky on June 17, 2015 at 8:40am

Hi 

my setup:

Mission Planner 1.3.28

ArduPlane v3.3.0

When I try to calibrate transmitter (initial setup-> mandatory HW-> radio calibration-> calibrate radio )
I am not able to calibrate throttle channel. Slider work well but red lines ( corner case value ) does not move.

3691217465?profile=originalWhen I start amp throttle work for a while (5s) then stop reacting

Any idea what can be wrong ? 

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Wattas June 17, 2015 at 9:13am

     Arm throttle

    • Tomas kasanicky > Wattas June 18, 2015 at 4:01am

      As usual my fault :). I am building flying wing and I do not use rudder, so when I make a connection between receiver CH4 and AMP input 4 everything works properly. Thank you Watts

    • Tomas kasanicky > Wattas June 17, 2015 at 10:44pm

      Thank you for your early reply. In config/tuning is paramater set as  ARMING_REQUIRE=0, but I can not stil control  throttle. So I have no idea what I am doing wrong :( 

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…