Hello everyone
I have searched hi and low trying to find out how to set up the inverted v-tail.
Pitch and yaw work well for the standard v-tail. But for the inverted v-tail if I get pitch to work I am unable to get yaw to work in the proper direction.
The air frame I am trying to config is the RMRC anaconda.
Replies
@Gregory,
I just completed setting up my Anaconda in the Manual mode.
Here is how I have it configured:
I setup the joystick throws according to the Wiki:
Ch 1: Roll left=low…Right=high
Ch 2: Pitch forward=low…Pitch back=high
Ch 3: Throttle down(off)=low…Throttle up=high
Ch 4: Yaw left=low…Yaw right=high
RCMAP_PITCH, 2 Left V-Tail servo
RCMAP_ROLL, 1
RCMAP_THROTTLE, 3
RCMAP_YAW, 4 Right V-Tail servo
VTAIL_OUTPUT, 2
Typicalaimster had his VTAIL_OUTPUT set to 3, but that did not work for me. I would have had to reverse the right and left tail servo connections to get that to work.
I still have to check the FBWA servo movements which might require me to check one of the "reverse" boxes for either PITCH, YAW, or ROLL.
Regards,
TCIII AVD