ILook+ OSD how to connect

To connect a N1 OSD to the Ilook+ do the following:

Take back off the Ilook+ and remove the circuit board connected to the lens (just 2 screws)

Unplug the 6 pin Jst Sh connector from the circuit board.

Cut the red wire at position 1 on the connector, this is the video feed.

Solder a wire to each end of the red wire and take out through vents at back of camera. 

Solder a 3rd wire to the main circuit board where the white wire from the Jst connects, this ground.

Take this out the back of the camera.

You now have video out, video in, and ground to connect to the N1. The ground wire can be connected to both the video in and out.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Activity