Hello, I know these Xbees are not officially supported but I was wondering if anybody has had success using them with the recent Mission Planner.
I have the XB24P (not the zig bee) and I can succesfully connect via CLI on the Arduino Serial Monitor.
I can run the tests and configura basic stuff. But when it gets to connect via mission planner the load of vars fails.
It starts loading vars, and then for some reason stops,and retries three times.
After the third time it outputs an error regarding communicatione error.
I tried @115200 an 57600 with same results.
Anybody has some suggestions?
Emile
Replies
I can only suggest going to MP->Help->Show Debug, restarting MP, and looking at the cmd.exe window (behind MP) while you try to connect/load params. I think it may show some more information, perhaps failed crc? I'm not sure what it will show, but it might be helpful.