Discussions

Mode switch problem

Posted by Simon B on April 19, 2010 at 6:24pm

Hi all,

Can someone help me with setting up the mode switch.

I'm using a MX22 with a spektrum module.

I have run the Radio tester and servos in nuetral position about 1500.

When I run the mode switch test, nothing happens. MUX led is always off.

STAT Led is solid yellow.

Serial monitor  reads;

Init Ardupilot Control Switch Tester 2.5.0

##0 / MANUAL.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Simon B April 19, 2010 at 9:38pm
    Chris,
    The + pwr is just disconnected during that photo
    I'm tearing my hair out here, bugged If I know why it isn't switching.
  • Simon B April 19, 2010 at 6:59pm
    Hi Chris,

    Here is a pic of the connections

  • 3D Robotics
    Chris Anderson April 19, 2010 at 6:26pm
    Can you upload a picture of your board, with the RC cables all connected? It sounds like you've got something plugged in wrong.
This reply was deleted.

Activity