mRobotics Pixhawk / ESP8266 / MavESP8266 (1.1.1 firmware)

Hello,

I am currently trying to establish a UDP connection via Wi-Fi using an ESP8266 development board.

I am able to flash the software using the NodeMCU flasher, and am able to generate the PixRacer WiFi signal from the firmware and am able to connect to it via my computer.

However, once I establish the connection, when I try to connect via UDP on MissionPlanner, I cannot establish a MavLink connection (the screen just keeps on loading). When I try to /getstatus, there are no packets receiver or sent.

Attached is the guide I used:

https://rays-blog.de/2016/10/21/224/adding-wi-fi-telemetry-to-pixhawk-flight-controller-with-esp8266-module/

Some photos of my NodeMCU board, with soldered points (Vin, RX, TX, Gnd).

Thank you.

IMG_1171.jpg

IMG_1172.jpg

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

This reply was deleted.

Activity

Liam left a comment on Agricultural UAVs
"Hi
I'm Liam from T-MOTOR. I would like to reach out to see if there is any possibility for us to work together.
We are a propulsion system manufacturer who offers motors, propellers and ESCs for all kinds of drone applications which vary from secur…"
Jun 30
Richard Cox left a comment on Australia
"Anyone in the DIYDRONES Australian subgroup based in Alice Springs, NT?
I am experimenting with Ardupilot (standard Arduplane), Pixhawk 4 FC in a 4-ch
RC "AXN Floater Jet" foamy plane..."
Jun 29
Omar Sykes left a comment on Australia
"Hi everyone, I am looking for someone who is good at drone building, repair and software in Adelaide. Please give me a call on 0477 319 219."
Jun 29
More…