No Servo Control

Hello,

 

I have got my ardupilot up and running, everything is working fine with all components (shield,IMU, and ublox GPS) now i tried to connect the servos through the board.  However, they are not responding to inputs given by the controller.  i know the servos work properly without the board and just hooked up the the servo reciever.  I am using channel 4 for the rudder control and have done all the steps in reading and writing channel four as described in the manual.  What could be some of the issues that would cause it.  I am using a Spektum DX6i controller.

 

Thanks for any help

 

 

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

This reply was deleted.

Activity