Hello Everyone,
this is my first time working with and attempting to run arducopter on an apm 2.8 board. I have everything set up and ready to go, and can arm my motors, but once they start spinning at their idle rpm's (min throttle) any throttle input past that sends my motors off at 1 speed no matter what percentage my throttle is at except minimum (when they shut off back to their idle speed). i have no control over the throttle on my copter, and my ESC's, radio, and everything are calibrated. If anyone has any idea what could be going wrong or knows how to fix this i am dead in the water and ready to quit on this board, so your help is much much appreciated.
Thanks
Replies