Discussions

outputs channel 7, 8

Posted by etienne.t.micallef on May 20, 2012 at 6:12am

doing a hexa copter.

Cant for some reason calibrate the motors / esc on channel 7, 8. the escs do a constant beeping. Tried both manual and automatic calibration several times. even uploaded firmware around 8 times.

When i try to check the motors obviously motors connected to channel 7, 8 do not start.

Any ideas on why the 7th and 8th channel are not working please

Etienne

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

etienne.t.micallef May 20, 2012 at 6:50am

i think i found the proble,m, iw in a hexa copter channel 7, 8 are not used!

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile

Santiago Perez liked Santiago Perez's profile

More…

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.